Free Barber practice test
Free Barber Practice Test: Hairstyling
20 questions on Hairstyling, drawn from the written (theory) state board syllabus. Answer them all, then check your score. No account and no card.
Questions 1 to 20
Choose an answer before you open the explanation. Guessing first is what makes the explanation stick.
Hairstyling Question 1 of 20
According to AAD, what helps reduce damage from heated styling tools?
Check answer
Correct answerB. Limit heat use, choose low/medium settings and use heat protection
Why this is correct: Limit heat, use low or medium settings and apply a heat protectant.
Hairstyling Question 2 of 20
According to the Dyson Corrale guide, what should change for hairline sections?
Check answer
Correct answerB. Reduce temperature
Why this is correct: The guide specifies reducing temperature for hairline sections.
Hairstyling Question 3 of 20
For Conair HS11RX, where should a hot roller be held while rolling hair?
Check answer
Correct answerA. The roller ends
Why this is correct: Hold the roller by its ends, avoiding the hot center.
Hairstyling Question 4 of 20
According to Dyson Corrale preparation guidance, what state should hair be in before straightening?
Check answer
Correct answerA. Dried
Why this is correct: Corrale is used after drying; do not generalize this to every steam-based device.
Hairstyling Question 5 of 20
For fine hair, what does Corrale guidance favor over maximum heat and force?
Check answer
Correct answerA. A lower setting suitable for fine hair without excessive pressure
Why this is correct: Choose the lower setting suitable for fine hair and avoid excessive force.
Hairstyling Question 6 of 20
With other conditions comparable in Conair roller setting, what do smaller rollers and sections generally create?
Check answer
Correct answerA. Tighter curls
Why this is correct: Smaller rollers and sections give tighter curls; hair length and timing also matter.
Hairstyling Question 7 of 20
To make a round face appear longer, which design element can be added?
Check answer
Correct answerA. Height
Why this is correct: Adding height at the top creates a longer-face impression.
Hairstyling Question 8 of 20
In Framesi Smoothing System step 3, how far should the dryer stay from the hair?
Check answer
Correct answerA. 2 inches (about 5 cm)
Why this is correct: The guide specifies at least 2 inches for this system.
Hairstyling Question 9 of 20
According to Corrale guidance, how is the straightener moved along a section?
Check answer
Correct answerA. Glide evenly toward the ends
Why this is correct: Glide evenly toward the ends rather than holding hot plates still.
Hairstyling Question 10 of 20
According to AAD, how should braids pulling tightly at the hairline be adjusted?
Check answer
Correct answerA. Loosen them, especially at the hairline
Why this is correct: Prolonged tension can cause traction hair loss; reduce tension rather than treating pain as normal.
Hairstyling Question 11 of 20
According to AAD, what can choosing shorter locs help reduce?
Check answer
Correct answerB. Weight pulling on the hair roots
Why this is correct: AAD advises shorter styles to reduce weight; this is not a loc-formation technique or a guarantee against hair loss.
Hairstyling Question 12 of 20
According to AAD, how should natural hair be prepared before a weave or extensions?
Check answer
Correct answerD. Remove product buildup and condition the hair
Why this is correct: AAD recommends clean, conditioned hair before adding extensions; follow the specific attachment system too.
Hairstyling Question 13 of 20
According to AAD, what should be done before washing natural hair with clip-in extensions?
Check answer
Correct answerA. Remove the clip-ins first
Why this is correct: This recommendation is for removable clip-ins, not every extension system.
Hairstyling Question 14 of 20
In the NIC document’s three-strand overhand braid, how does an outer strand cross?
Check answer
Correct answerB. Over the center strand
Why this is correct: Overhand uses an over-center crossing. The 2011 NIC document supports technique, not current CA/TX exam rules.
Hairstyling Question 15 of 20
Where does the NIC document place an outer strand in an underhand braid?
Check answer
Correct answerC. Under the center strand
Why this is correct: Underhand differs from overhand by crossing under the center strand; it is unrelated to shaving-area numbering.
Hairstyling Question 16 of 20
According to the NIC technique instructions, where does braid removal begin?
Check answer
Correct answerD. At the ends, working toward the scalp
Why this is correct: Unbraid from the ends in sequence rather than pulling at the roots; this is not a current practical-exam schedule.
Hairstyling Question 17 of 20
What does the NIC technique document use to remove a bonded extension weft?
Check answer
Correct answerA. A bond remover following manufacturer directions
Why this is correct: The source calls for manufacturer bond remover; different adhesives do not necessarily share solvents or removal methods.
Hairstyling Question 18 of 20
According to Jon Renau, how should ear tabs be checked when putting on a wig?
Check answer
Correct answerB. Even on both sides just in front of the ears
Why this is correct: Check balanced ear tabs and hairline position before adjusting; this is manufacturer wig-application guidance.
Hairstyling Question 19 of 20
According to Jon Renau, which part is used to adjust a SmartLace wig?
Check answer
Correct answerC. The ear tabs, without pulling the front lace
Why this is correct: The manufacturer warns against stretching the lace or sliding fingers underneath; adjust using ear tabs.
Hairstyling Question 20 of 20
How does the Jon Renau care card wash a conventional synthetic wig?
Check answer
Correct answerD. Cool water, lather in one direction without rubbing
Why this is correct: This is synthetic-fiber care, not a universal protocol for human hair or every cap.
Practice content notice: These are original study questions, not recalled or official exam items. Exam providers, timing, passing scores, and state-law coverage can change; verify current requirements with your licensing board.